Zavio D5111 Installation Guide download pdf (Page 3)

Install the hardware and make all cable connection

a. Wall mounting and Ceiling mounting

1. Attach the alignment sticker to the wall/ceiling and drill two pilot holes into it.

2. Hammer the supplied plastic anchors into the holes.

3. Align the three holes on the base of camera with the three plastic anchors on the wall and ceiling, insert the

supplied screws to the corresponding hole and screw them.

b. Connect all cables

b1. Power over Ethernet (PoE)

1.Using a standard RJ-45 network cable, connect the IP Camera to a PoE-enabled Hub / Switch / Router

b2. Without Power over Ethernet (PoE) connection

1. Connect the power adaptor to the IP Camera.

2. Using a standard RJ-45 network cable, connect the IP Camera to a normal Hub / Switch / Router.

1 2 3 4 5 6 7 8 ... 11 12

No comments

Zavio D5111 Installation Guide Page 3